Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference b/w HT & LT and the range of HT & LT ?
- 22 Answers
- 66359 Views
- AF, Schneider, I also Faced
- E-Mail Answers
Answer Posted / mike
Less say if you had transformer in a station it was a 100kv
to 44kv the breaker between the bus an high side of the
transformer protecting it from a fault would be the high
tension. Once it leaves the low side of the transformer it
goes to a breaker that is between the transformer and the
low side bus this would be your low tension. These breakers
have ct that protect the bank with differiential relays.
| Is This Answer Correct ? | 12 Yes | 30 No |
Post New Answer View All Answers
What is gross error?
What is distance between electrical panel to land ?
advantages and disadvantages of inverse definite minimum time RELAY
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
Give some example of fault limiting devices?
What are the uses of stepper motor?
what is the ms flat constant for calculating earth mat design calculation?
Explain how you decide what size of electrical wire do you need?
How much no load current of synchronous motor
why Lightening Arrester Probe sharp at Top of telecom tower.
What is mean by Sensitive Earth fault & what are the effects
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
plz tell me,ht and lt panel terminals in substations explain beiefly
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
