Answer Posted / s.yuvaraj
Bearing is used to minimize the friction between two moving
or 1 moving & 1 stationary parts so as to reduce wear and
tear of the parts hence by increasing their service life.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
If any changes done in the process of production what that is called.
Which instrument measures speed in a car?
Explain the opening and closing of water to the bowl of the purifier
What is blower? Partlist of blower.
Name the different shops?
What is meant by gear ratio?
What is the purpose of bilge separator
I am completed diploma in mechanical in 2002, i have 5year experience in materials (purchase) dept,i want to do SAP cource in MM module, i want to know can i complete SAP after diploma cource only, is it usefull to me for further Job opening.
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
What is the boiler bank position?
how can we find the discharge pressure of the pump with the use of flow and NPSH?
What type of cross-section is usually of a chisel?
Which rays are produced by cobalt-60 in industrial radiography ?
Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?
What is the normal vacuum pressure in a steam turbine atmospheric condenser? What would cause the press to falls?