What are the conditions considered while evaluvating MARGIN
OF SAFETY for newly designed mechanical components....? or
Explain its steps...??
- 3 Answers
- 5512 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthick
i think margin of safety is nothing but fcator of safety.
factor of satfety is defined as the ratio of ultimate
stress to allowable stress and it should be always greater
than one
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
Why the transformer is mostly used aboard the ship?
What is the different types of surge tanks ?
Compare the prandtl numbers of Air, water and Liquid metal. If prandtl number is more what do you understand?
If saturated temp of water is 99.8degc at atmospheric pressure,then how the water of sea is evaporated at normal temp
how much efficiency loss will took place in a steam turbine due to low vacuum
What are the different values that need to be determined in order to design a cylinder for an ice?
a three phase squirrel cage induction motor runs slow? list all possible reasons for such fault.
Enumerate the cause of pumps low delivery of water
ADVANTAGE &DISADVANTAGE OF USING LPG IN CAR?
ongc recruitment sample paper for asst.technician technical
Name the grade of forged steel use for manufacturing of master connecting rod and why to prefer that grade.
what is tooth profile
• Why not 4 phase & 5 phase
At 50 Centigrade (Fuel oil) what is its cast?
