In a single
phase converter, the no. of SCR conducting during overlap?
a.1 b.2 c. 3 d. 4
- 3 Answers
- 9044 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala
b)2
| Is This Answer Correct ? | 21 Yes | 5 No |
Post New Answer View All Answers
What is center gravity load in substation?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is ratio of copper wire size and current ?
What is sensitivity of a measurement?
How Can you do Maintenance of ACB of 2000Amperes
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
What is the complete procedure of erection of electrical panel in industry
whatis the commertial spec. of distribution boards ?
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
What do you understand by oldham's coupling ?
Operation of isolators.
how to size H.T & L.T Panel ?
As an electrical engineer what are the responsibilities which i can hold in TCS?
