clock frequency of 8051 microcontroller.
Answer Posted / srujana
8051 can support 4 mhz to 30 mhz ,but generaly 11.0592 Mhz
freq. is use with 8051 bcoz of baud rate
Is This Answer Correct ? | 91 Yes | 7 No |
Post New Answer View All Answers
How is thermal management done in electronic circuitry?
What is the difference between emulator and simulator?
steps which are performed in the bios POST codes
Can Somebody tell me what should i do if i hadn't filled form for the next mahagenco exam for any new vaccency. if any one can provide me contact email to mail some one at mahagenco office, please mail me if any thing you can do on pratikgupta05yahoo.in
the configure that is worst effected by ?
WHEN SUB. A IS HPLMN AND B SUB. IS ROAMING FROM ANOTHER PLMN CAN ANY ONE TELL ME THE CALL FLOW FOR THIS?
can any one tell difference between 802D and 810D???
How many Antenna use in 6+6 with 2-way Diversity.
how can i get old question papers and solved problems of vtu university karnataka...... if u know plz do reply
What are the test parameters to check the proper functionlity of TCP/IP protocol.
Dear all, I am working as engineer in an electronics industry since 3 years,and i would like to apply PR visa for australia,i got 6 bands in all modules in ielts(general).please let me know what should i do now?
Derive intrinsic stand off ratio.
Where the two port networks is used ?
compare the delay in sending x-bit msg over k-hop path in ckt switched nw nin lightil loaded packet swithed nw. the ckt setup time is s per hop,the packet size is p bits n data rate is' b' bps under what condition does packet nw have lower delay?
Explain what is associate law?