Interested to Buy Any Domain ? << Click Here >> for more details...
Questions :-
HR-
Q.1 about yourself & family background ?
Q.2 Why u choose Power sector as ur carrier starting not any
other sector ??
Q. 3 What think abt NTPC ?
Techincal Questions:-
Q.1 about Vocational Training……What u did , see the main
equipments….etc
Q.2 Why a transformer Noise during its running condition ?
Q.3 about transformer oil material & Test name for the
measurement of its dielectric strength & wht will u do if
its dielectric strength goes low ? ……..some discussion type ?
Q.4 What is relation between transmission lines &
Communication lines ?
Q.5 Which Machine u will prefer to use at a place where
flammable gases are coming out & why ?
Q.6 how fault in an electric system is detected & hw
protection of equipments is done ?
Q.7 Why we didn’t feel electric shock in an electric train ??
Q.8 Anything u want to ask from us ??
- 44 Answers
- 49531 Views
- Akona Engineering, Bhel, BSES, Cranex, DRDO, JCB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / vj
Please send best possible answers to these questions at mail
address vj1.2007@rediffmail.com
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to measure the earth resistance value in a concrete pavement(flood light area)?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
why we are using Load factor?
how mass curve differs from hydrograph.
what is the voltage between earth & neutral in 3 phase electrical connection.
what is the control circuit for operating the clean room air shower
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
give single line diagram of D.G distribution form alternator to main L.T panel?
list the advantages of RCCB over other circuit breakers?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
if sf6 gas low in gis what will happen
Why neutral is not used in three phases dol starter
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
What is servo lock in CNC how they work and if any parameter for them in CNC machine
