Interested to Buy Any Domain ? << Click Here >> for more details...
In a d.c circuit, if current and resistance are known, power
(P=I*I*R) can be determined. This relationship also applied
to an a.c circuit. Comment the reason for this.
- 3 Answers
- 5337 Views
- I also Faced
- E-Mail Answers
Answer Posted / lol
because resistance and current in an a.c circuit is the
same. Only the voltage is changing.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Why to keep capacitor bank off while generator running.
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
what is the difference between Power and Distribution transformers ?
advantages and disadvantages of inverse definite minimum time RELAY
Define active and passive network?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
What is “pu” in ee?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
What is the general system requirement of alternator?
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
why we used dc supply for field in dg set
what is the use of expulsition protective gap in 11Kv line.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
