why commutator is attached with only dc macine
- 8 Answers
- 10900 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / amirtha
becoz to get dc output we are conneting commutator.from the
armature commmutator collets the ac current and convert it
to dc.tnis is not needed in ac machine
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
What happens when two positively charged material is placed together?
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
what is efficient motors and how it is different from normal induction motors
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
What is the name of the winding to which supply is given?
How to work definite,over pluxing,revers power,OSR relay
what is the difference between gas group b and gas group c electrical equipment construction wise?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
Why Transformer Neutral having one earth pit ( more earth electrode resistance) whereas body have many earth pit ( less earth electrode resistance)?
what is the Transformer Impedence?How can calculate?
How DC earth leakage currents can be reduced ?
