Interested to Buy Any Domain ? << Click Here >> for more details...
what is the minimum distance between substation wall and LT
panel outer surface?
- 3 Answers
- 12699 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / niti
750mm
| Is This Answer Correct ? | 28 Yes | 5 No |
Post New Answer View All Answers
why you don not show protection and type of isolation in key single line diagram?
When we use 3 terminal resistor?
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
Define gain margin?
State the methods of improving power factor?
what is high and low cut off voltage of BB and DG at SPS????????
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What is knee point voltage?
previous year paper of ntpc bhel for degree in electrical enng
for compensate 315mh inductance ,how many capaciance required?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
What are root loci?
What is the difference between diode and a transistor in terms of the direction of current flow?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
