Interested to Buy Any Domain ? << Click Here >> for more details...
What are the starting currents of different motors and also
what are the running currents, and idle currents?
- 6 Answers
- 14022 Views
- I also Faced
- E-Mail Answers
Answer Posted / dharababu
IN MOTORS THE EQUATION FOR BACK EMF IS GIVEN BY
Eb=V-IR,
SO ARMATURE CURRENT I=V-E/R
AT THE TIME OF STARTING THE STATOR FLUX WHICH PRODUCES BY
SUPPLY,WILL NOT LINK WITH ROTOR AND THERE IS NO BACK EMF
PRODUCES IN ROTOR I.E I=V/R.
AS THE RESISTANCE OF ROTOR WILL BE VERY SMALL , THE
STARTING CURRENT WILL BE VERY HIGH .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
What is stepper motor. What is its uses?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
why r we using shell transformer for low voltage
Define noise?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
what is die electric strnth of transformer ?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
Is neutral transformer can be called as control transformer?
Explain few advantages of electric traction system?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
