Answer Posted / ghost rider

Abobe two reply explained correctly "what is vector group".
The answer to the last question "why it is needed" is as
follows:-
By virtue of constrction & terminal connections of the
transformer, a difference between primary vector &
secondery vector occurs. We need to know the same for the
following reasons:-

1)Matching of vector group is required (to avoid
circulating current/ fault ), when 2 transformer need to be
operate parallal on a common bus/system.

2) to provide transformer differential protection correctly.

etc

BSNL TTA EXAM QUESTION

2179

---

what is the circutor?why we use it ?

2332

---

What is the efficiency during maximum power transfer?

1238

---

How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.

4773

---

What is milivolt dop test in Busducts? What is its significance & procedure to do the test?

2096

---

How to size fuse? How to size MCB?

1522

---

What are the different types of hydro schemes?

1267

---

How to calculate multiplying factor of dc energy meter

1666

---

Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?

1493

---

how open delta PT works & what is its construction?

2250

---

I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.

2113

---

how is capacitor bank look like

2405

---

what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?

2398

---

What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?

2930

---

What are the factors which influence the choice of specific magnetic and electric loadings of a synchronous machine?

2096

---