Interested to Buy Any Domain ? << Click Here >> for more details...
In what way does the variable ratio-arm improve the
usefulness of the wheatstone bridge?
- 1 Answers
- 5849 Views
- I also Faced
- E-Mail Answers
Answer Posted / balaji
when ratio-arm value is low it is use to find very high
unknownimpedence value likewise when ratio-arm value is high
it is use to find very low unknownimpedence value
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
How to calculat the ratio of HT\LT in energy meter
advantages & disadvantages of Lagging and leading power factor .
A jet of fluid strikes a plate What was the force required to counter it?
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
is there any phase difference occurs while primary and secondary side mutual induction occurs?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
how does it help for selection of a transformer.
State the points to be considered for selecting a particular type wiring.
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
What is non-minimum phase transfer function?
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
how many load we can take for lighting
how to design the heater in temperature control unit to heat 50KL of water?
