Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / s
Power factor is the ratio of real power flowing to the load
to apparant power.It is relevant because the power which we
are giving(Apparant power) is not utilized fully because of
the inducatance and capacitance of the system.Apparant
power is expressed in VA because on applying a potentail
difference between two end of a conductor current is
flowing through the circuit. This is the power given. Real
power is the power utilised by the inductive load
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
why does make gain margin and phase margin on same plot.?
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
boiler is running in rankine cycle and deisel generator is....?
how can we calculate the ratio of caustic soda and water in lrs.
What are the three constants associated with a steady state error?
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
List out the the types of Mounting Light fixture?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
what are factors to be consider in electrical installation like load factor,diversity factor .....
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
What is the Surge suppresor? Why using in a UDB's and How it works?
