Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / farha
Earth is the universal reference which is assumed to be at
ZERO potential. While neutral is the common connection
between three phases in a star connected circuit. Earth is
essentialy at zero potential while neutral potential
depends on the unbalance between the phases.If the phases
are balanced, neutral has zero potential while in case of
unbalanced system, neural has some finite potential.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
Why control of DC motor is simpler?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
what is the id1 & id2 setting in differential protection relay of CSPC?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
What is the importance of earthing?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
Why negative feedback is preferred in the control system?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
Why should we hire you over the others waiting to be interview?
how to identify the cable quality and what is flame proof cable
How to Calculate the Fault Level of Electrical Installation
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
