Interested to Buy Any Domain ? << Click Here >> for more details...
wat is the importance of reactive power in power
generation.....if it is zero means wat will happen to
system........
- 22 Answers
- 43005 Views
- Bhel, Jindal, I also Faced
- E-Mail Answers
Answer Posted / shinyvikram ganji
ya this a great question ...
the power transfer depends on the formula
P = {(E1*E2)/X} SIN(DELTA)
SO WHEN EVER THERE IS NO REACTIVE COMPONENT POWER IS 0
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
66kv under ground cable how to layaing in ground any special case two ckt r runing
describe the constructional features of an auto transformer and its principle operation
What are test signals and their significance?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
What are the common sources of energy?
what is (+) and (-) in generator field detector stand for?
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
as a electrical student why should i hire you?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
Why different Pressure switch used in marine boiler water circulation system
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
