Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sm
Thyristors or silicon controlled rectifiers (SCR) as they
are sometimes known may appear to be unusual electronics
components in many ways, but they are particularly useful
for controlling power circuits. As such these electronics
components are often used for applications such as light
dimmers, and there may be thyristor circuits used in many
power supply applications. Thyristors are simple to use and
cheap to buy and often thyristor circuits are easy to build
and use. All these reasons make thyristors ideal components
to consider for many applications.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Definition of reverse and acting controllers:
send me last 5 years questions asked in rrb chennai, for section engineer
What is the constant voltage unit?
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
How to calibrate smoke Dectector
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
pls give me presant awerness quistion and answer in my emailid.
Whatis the reset ofset and control system in instrumentation
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Explain why plc require in analog input 4-20amp & 0-10 volt?
Explain an adaptive / self-tuning controller’s major draw card.
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
