Interested to Buy Any Domain ? << Click Here >> for more details...
what is the principal of flow transmeter,level trans
meter,presser transmeter?
- 11 Answers
- 27918 Views
- Nestle, Reliance, I also Faced
- E-Mail Answers
Answer Posted / roshni
FLOW Tx->MEASURES FLOW AND TRANSMITS O/P TO CONTROL ROOM
LEVEL Tx->MEASURES LIQUID LEVEL(MOSTLY)TRANSMITS O/P TO
CONTROL ROOM
PRESSURE Tx->MEASURES PRESSURE OF FLUIDS AND TRANSMITS O/P
TO CONTROL ROOM
| Is This Answer Correct ? | 10 Yes | 20 No |
Post New Answer View All Answers
send me HPCL paper
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Explain the difference between plc and cnc?
How to calibration a control valve?
How digital input and digital output 's are working in dcs
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
how to work static pressure sensore how to work dpt
what is intrinscily safe system and where we use?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
what is difference between fork type and capacitance type level switch. where it is using
Where is wet leg is used?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
why is not useing in boiler skin thermocople
what is maxdna ?. explain about the software details.
