Answer Posted / shafi kukkad
for controling we need continue supply in any condition
so,in Electrical Storage only by Using Battery which input
and output is DC. so whn our normal system fail this DC
comes from direct from Battery bank (which chareged by DC
UPS.) no any other arragment required.
if we using AC Controling we used AC UPS syestem, which
done first AC to DC and charged Battery. and whn Fail
normal control supply (which is AC), thn first Battery
output DC convert into AC and give control supply.which is
not reliable and complex arragement.
| Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
How to find out damper winding failure for synchronous machine?
what is the acceptable limit value for Desolve Gas Analysis/
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
Do closed loop systems require manual input?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
Define the three phase formula fuse.
Who many reason of ignition fail ?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
How can we measure the residual voltage in dc machines?
What is the difference between relays and contactor construction wise?
how to operate and maintenance of 1500 kva diesel generator set