Answer Posted / lenin kumar

When ever you purchase the RSlogix 500 software they will
give activation flopy with the CD.After installation, to
open the software you need to instal the
Activation.normally it will be available in flopy.To
activate You have to go through Start-programs-rockwell
software-Utilites and follow the instructions.

Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.

1945

---

Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?

1871

---

How to Calibrate Radar Level Transmitter in Field

1230

---

How to calibrate smoke Dectector

1624

---

If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?

2066

---

i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......

2039

---

How earthing can be checked????

2396

---

What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?

2077

---

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

1946

---

Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?

915

---

can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know

2112

---

What are the different types of thermistors used in industries? How to the operation of typical thermistor?

1950

---

I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .

1955

---

Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com

899

---

why is an oxygen sensor used in a boiler stack

7273

---