Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of choke on tube light fitting
- 37 Answers
- 81007 Views
- Bhel, Dharma, HSBC, TCS, I also Faced
- E-Mail Answers
Answer Posted / rathnam
the property of the inductor is to oppose the rate of
change of current through it suddenly. At the time of
starting it requires high voltage to ionise the gas (
through creating potential difference between the
electrodes) in the tube so choke creates required potential.
The starter is same as that of a capacitor, to improve the
power factor the total system(connection of R and L) it is
required.
| Is This Answer Correct ? | 30 Yes | 8 No |
Post New Answer View All Answers
What is the function of the generator exciter?
How is the gain affected by the introduction of feedback in a control system.
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
how to check avr of dg set of 125kva
why the carbon brushes are broken in srim while the motor runningtime
How to calculate energy stored in an inductance?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
Please define ohm’s law for a.c (alternating current)?
how to calculate slip ring induction motor stator and rotor currents??
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
how to calculate the breaking capacity of different breakers.
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
