what will be happen if we apply D.C supply to the
transformer
- 14 Answers
- 19546 Views
- CCBPL, I also Faced
- E-Mail Answers
Answer Posted / nitin
IF DC SUPPLY IS APPLIED 2 TRANSFORMER, THERE WOUNT B ANY
RATE OF CHANG OF FLUX IN THE PRIMARY COIL. THUS THIS NON
CHANGING FLUX B INDUCED TO THE SECONDRY. SO NOW ONLY 1
SPIKE OF TRANFORMED FLUX WILL APPEAR THERE, SOONLY A
MOMENTOUS VARYING CURRENT WILL BE OBSERVED IN THE SECONDRY
OUTPUT. AFTER THAT SPIKE THERE WILL BE NO OUTPUT. IN
OVERALL THE TRANSFORMER WOUNT FUNCTION.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
Graphs of measuring power and speed on dc motor
gas turbine genrator reactances
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
How can we increase fuel-power ratio of any DG set?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
what & how to check the lightning arrester
what is conductor copnstant of ab cable
why induction motors are rated at 0.8 power factor.
how to select battery for 15 KVA UPS with formula
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
