what is the difference between RS 232,RS 485,RS 422, how
they different from each other
Answer Posted / win
rs232 is half duplex & rs485 id full duplex in its function
which depends on programming
Is This Answer Correct ? | 18 Yes | 99 No |
Post New Answer View All Answers
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
How to Calibrate Flow Switch in field
send me HPCL paper
What is frequency factor in massflow meter? When using frequency output?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
What is the basic difference between Modbus and CAN Open Protocols
How oil line flow measured?eplain about instruments used and working principle?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
what is the electrical operation procedure for switching on 27.6MVA electric furnace.
what is difference between HOT permit and cold permit
can we create an interrupt in plc through scada?
what is the usage of QDV & VOLUME BOOSTER
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?