Answer Posted / pappu meena
Jel earthing should be done in rock/hill areas.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
what is the affect of earth's magnetic field on the frequency used in aircraft???
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What is the physical significant of power factor?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
Do u know any one? how to find out in motor rated amps? formula?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
what is the electrical?
why electronic instruments is more favorable than electrical?
