Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 356598 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / divihtin
ELECTRONICS - Flow of charge(electrons) through non-metal
conductor.For instance, Silicon ,which is a non-metal comes
under electronics.
ELECTRICAL - Flow of charge through metal conductor.For
instance, copper ,which is a metal comes under electrical.
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
why we use single core 630mm2 cable for transformer secondary side
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
List the power rating of any 5 important electrical appliances used in houses.
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
What is meant by rotor?
we have 15 ampere variyac but we want 30 ampere variyac what we do
Witch do depand of Power factor and theory of power factor?
How to select the cable and voltage drop in circuit?
Which motor connection is preferable star-delta or delta-star?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
