we hav seen in electric engine of trains only 1 wired slidng
conecctn is there frm ovrhead line,howevr to complete a ckt
in dc postv n negtv two conection has to b there...so where
is tht negative is been connectd or where it is grounded...?
- 5 Answers
- 6505 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / naresh
it is completed through therails to ground through the
wheels
| Is This Answer Correct ? | 20 Yes | 0 No |
Post New Answer View All Answers
What is error of a measurement?
What is kirchoff ’s current law (kcl)?
Explain how you decide what size of electrical wire do you need?
state working of halogen lamp?
How to calculate Temp from Resister from PT100 equation,
What is ramp signal?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What are the advantages and disadvantages of negative feed back?
what is the isolation transformer. what is the isolator?
What does the letter CTNM in negative phase sequence relay means?
What is servo motor? what is its purpose?
What is the use of Surge Capacitor in LAVT?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
What would be the size of wire used for 2 Ton of window A.C?
