Answer Posted / pratheesh
One methode is use a Clamp-on meter which is capable to
measure DC current also.
For small amount of currents(say upto 5 or 10 ampere)we can
connect one suitable range ammeter in series with the
circuit.
If the amount of current is too high( say 100s of ampere)
we can use series resistors and by measuring the voltage
drop across this resistance with a voltmeter, we can
calculate the corresponding current flow thrugh the power
cable.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Swg formulae
What is the function of retrip in busbar?
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Can we put 3 layers of cable tray while installing tray
1.what is mean by 8/20 micro sec waveshape
what is the function of capacitor duty contactor in an capacitor panel???
Should power factor be low or high?
wat is the first thing dat is needed, 2 lay a cable in some area??
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Please give me a erda placement paper
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
