Answer Posted / arjunkarnati

we need around 800 to 1000 volts to start ionisation of the
medium which is present between the 2 electrodes of the
tube.once the ionisation starts the conductivity of medium
increases and 110 volts is sufficient to sustain the
emission of electrons from electrodes.
so to produce such a high voltage we are using choke.
once it starts to reduce the 230V to 110 volts we are using
the same choke.
so how this choke is producing around 800 to 1000 volts at
starting.
as we know inductor opposes the rate of change of current.
here we are making current I which is intially drawn to
zero with the help of bimetallic contacts present in
starter.according to formulae E=L*di/dt here L is constant
and di is equal to I-0 and dt is time taken for I to become
zero.
accordingly high voltage is induced and this voltage is
sufficient to drive the electrons from one electrode to
another electrode inspite of medium present between
electrodes. once tube start conduction, it needs only 110v
to sustain the illumination.so to reduce the 230v to 110v
choke just acts as a voltage limiter by dropping the
voltage.

List out the the types of Mounting Light fixture?

1614

---

hi,every one, i have to write the search paper on "performance policy optimization" of NGN (next generation networks). i need the material on this topic. can any body help me. please tell me any useful site where the good material is available and name of any reference book. it should be a great help for me.

1925

---

Why is tan-delta test and capacitor measurement done on alternator?

2215

---

For high frequency application we use which transformer?

1934

---

Can we use shunt trip coil instead of trip coil with protection relay for protection?

1741

---

3ph motor running with unequal kw and different pf what are the reasons

1877

---

Define branch?

1097

---

Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?

3808

---

What safety precaution are to be taken for avoiding electric hazards ?

1869

---

What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.

2226

---

1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?

4648

---

how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?

3685

---

What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?

2351

---

wheather the size of windings in motor and generator are the same

2024

---

how to setting voltage RTCC panel

1675

---