Interested to Buy Any Domain ? << Click Here >> for more details...
What is the significance of 3.5 core cable ????
- 8 Answers
- 22374 Views
- Intelux Electronics, I also Faced
- E-Mail Answers
Answer Posted / eswarudu.guddati
3.5 core cable means 3 cores is belongs to RYB (PH-1,PH-
2,PH-3) and .5 cor means either nuetral or ground conductor.
| Is This Answer Correct ? | 58 Yes | 4 No |
Post New Answer View All Answers
What is Plank's Law?
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
what is plunger and what's the use of it in motor alignment?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
what is control supply rating of a machine
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
Single line diagram for dbb (double bus bar)system.
boiler is running in rankine cycle and deisel generator is....?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
Why do we perform an open-circuit test and short-circuit test on the transformer?
