why current increases when voltage decreases in ac
system
- 10 Answers
- 25631 Views
- I also Faced
- E-Mail Answers
Answer Posted / pankaj
transformation ration k = n1/n2=v1/v2=i2/i1.
or k = v1/v2 = i2/i1 which is inversly proportional
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
how does a submersible pump work..?
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
what is meant by residual over voltage & residual earth fault ?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
Transmission through a short line depends on
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
single phase power supply give to separate one steel coup with water, what reaction create
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
what parameters are should nessary for control technic dc drive(in rolling mills)?
How cmd is calculated in case of energy neters
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
how to find impedance , mutual indatnce in transmission lines
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
how to select the isolation tranformer for siemens 802dsl cnotroller
