Interested to Buy Any Domain ? << Click Here >> for more details...
how do find power factor in practically and what it means?
- 3 Answers
- 7688 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhaskar
we need one wattmeter, voltmeter and amperemeter each.
observe the readings.
p.f. = Wattmeter reading/(volts*curr),ie. W/V*I
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
what is the purpose of shading ring or shading coil in electrical equipments.
how we can calculate the efficiency of a diesel generator ?
Why does amplifier gain reduce?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
what are the range of memory address in plc for L&T lx7 4A
how to meas-our losses for L.T & H.T
What is center gravity load in substation?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are chief characteristics of state-space method and its techniques ?
Which types of gate insttaled in static switch. Please give me answer.
What is meant by Load Encroachment in OHL Feeder Protection?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
how to calculate fuse rating for a motor
Is there any abbrevation for STUB in Stub bus protection
