Answer Posted / guest

hi sanjay
1. AIR SUPPLY
I/P input - 1.4kg/cm2
Out put - 0.2 to 1kg/cm2 ok

2.input signal= 4-20 mA

i.connect the air supply to input with the hepl of REGULATOR i.e 1.4kg/cm2
ii.connect the MASTER GAUGE to OUT PUT ok

Apply the signal

i. 4mA- 0 kg/cm2 (if not Zero/0.2kg/cm2 Adjust Zero adjustment Screw)
ii. 20mA-1 kg/Cm2 (if not 1kg/cm2 Adjust Span adjustment Screw) ok.

then 8, 12, 16mA.
min. and max. is ok the remaining will perfect automatically i.e 8,12,16mA.

and MAIN IMP POINT is ON the I/P's Ckt board Side 4 adjust ment buttons is there and adjust that buttons Direct and Revese Actions ok

Full form of KKS when use DCS.

3180

---

What is the use of each wire in three wire RTD

2510

---

How to work togather like sov,limit switch,proxy switch and booster in xv

4233

---

What is ultrasonic flowmeter?

1120

---

How an rtd work, and what volts/current goes to a rtd to measure the resistance?

1288

---

which type of signal used in instrument?

9870

---

How oil line flow measured?eplain about instruments used and working principle?

2068

---

Make Heater Process Logic.

2122

---

Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264

1965

---

if in a level tx height is given, how u calculate the ranges of the tx?

7738

---

how many types of preheaters are in cement industry & what r they can any body explain?

1772

---

What is instrumentation technologists and mechanics?

992

---

what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..

2165

---

How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?

2735

---

What is the difference between uv and ir scanners? and what is the workig principle of both

2380

---