Interested to Buy Any Domain ? << Click Here >> for more details...
In all the generators, the excitation supply is DC. What is
the significance of DC excitation? What will happen if AC
supply is given as excitation supply?
- 8 Answers
- 14249 Views
- I also Faced
- E-Mail Answers
Answer Posted / aero.diwa
ACCORDING TO FARADAYS LAWS, ONLY ONE ROTATING PART(FIELD OR
CONDUCTOR)AND OTHER SHOULD BE STATIONARY.
IF IT IS NOT DONE THE FARADAYS LAWS CANT BE APPLIED.IF WE
GIVEN A.C SUPPLY TO THE ROTOR OF THE ALTERNATOR(AC SUPPLY
HAVING HAVE BOTH +VE & -VE CYCLES)& ALSO THE ROTOR IS
ROTATING PART.IN THIS THE AC SUPPLY AND ROTATING ARMATURE
BOTH ARE IN MOTION,THATS WHY THERE IS NO INDUCED EMF IN THE
STATOR(B'COZ THERE IS NO CHANGE IN FLUX i.e E=d(PHI)/dt.)
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
i have interview in Pepsi company what type of question will ask please send the question and answeer
our industries ht line so power fluctation(once drop of power please rectify causes
What does bode plots shows?
State Maximum Power Transfer theorem.
How do apply electrical 'c'license......pls advice
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
reason of diode failure in alternator
What are dcs and plc?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
hr round
Why cables and busbar both needed in LT Panels?
how the inner and outer body is separated in aircrafts?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
how to calculate single phase motor efficiency ?
