Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suresh kumar
Motor will run with lesser speed and torque. But if the
load is same as in the case of 230VAC, current will be more
and motor may burn.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
Why neutral cable carry current.
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is instrumental error?
What is meant by analogous system?
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
What is the formula to calculate distribution transformer De-rating on iron losses basis
what happens if earth of 33kv cable is not connected to earthing pits? please send this query's answer to ngrm.sudha249@gmail.com
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
