Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naveen singhal
Check the diode by multimeter. If check the dc voltage
between anode and cathode , value is 0.7 V. and then change
the lead of multimeter on diode terminal check , value
should be come zero.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the fault or needs to be done when frequency in ac drives is not changing?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
What do you mean by dependent and independent voltage sources?
what are symmetrical and non symmetrical components in electrical installation.
what is the difference between general inverter and solor inverter clerly explain plz
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What id difference between power and energy?
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
what are the differant std sizes of cable trenches?
How shall i select the value of capacitor or inductor in a system?
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
