Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean CT Saturation? How to calculate?
- 13 Answers
- 113039 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / rishit
Sorry to say Mr Kiran Patil if CT is shorted ckted then it
will complete the ckt and save it from any further damage
and meter connected to that CT not able to read current
flowing from that CT.
There are two simple way to calculate the CT saturation
1. There is an instrument operates on 240v,50HZ known as RED
PHASE instrument it is an Australian instrument.
2. Primary injection method in this method we use an
instrument which can only provide current to both of the
primary position of the CT known as P1,P2 and secondary of
that CT are being short ckted so as to calculate the current
and with the help of tong tester we can calculate the
secondary current.
for example we are having CT ratio of 10/5 A and we are
providing primary current of 10 A and from secondary point
we are calculating 5 A current then CT are OK but if we are
getting lesser current than we must say that CT are saturated.
| Is This Answer Correct ? | 17 Yes | 50 No |
Post New Answer View All Answers
What is dynamo function in DG sets and draw block diagram?
What is precision of a measurement?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
what r the checklist while installing a 380 kva DG set
what is the cause of voltage dipp or swell in the transmission lines?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What is meant by coupling capacitor?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
why output is out of phase in case of common emitter?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
What is the phase relationship between the primary and secondary voltages of a transformer?
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
what is Anti-pumping?
hi....I am from india..i have completed my engineering in electrical and electronics field with 58.4% and my IELTS score is 5.5 bands....Recently i received my I-20 in computer and information science from Troy university in Alabama.On 18th i have a visa interview can u please tell me what type of questions i have to answer ??????
