What should be hight of CONTROL panel for access &
OPERATION
What is BIS & INDIAN STD for SAME?
Answer Posted / binu
The standard Height for Control Panel is 2200(H)X 800(W)X
800(D).
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the use of single seated valve?
What are different type of instrument cable
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
for oil & gas industries which zone is normally preferred? why? give its example?
What is the GK Value in Flowmeter?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
State some of balance principle’ advantages?
how do u calibrate the vacuum transmitter if it shows more reading
send me last 5 years questions asked in rrb chennai, for section engineer
why would you like to join our company
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
why we are using drum level control valve air to close?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
use of split range ? where it is used ? in which control loop it is used ?