Interested to Buy Any Domain ? << Click Here >> for more details...
What are the voltages at which electrical energy is
transmitted
- 7 Answers
- 10677 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / revathi
the electricity is transmitted at 110kv as primary
transmission and 66kv at secondary transmission
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
how to find impedance , mutual indatnce in transmission lines
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
what is ic 01,ic 06 ?is it types of cooling?
What are the protections for safe running of electric generator?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
what is transformor oil gread
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
Refernce currents are to be generated using refernce cueernts how can this be done
What is the automatic voltage regulator with servomotor?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Rules and standards of electrical control wiring ?
