Interested to Buy Any Domain ? << Click Here >> for more details...
Why capacitor bank does not require in DG Set?
- 21 Answers
- 68927 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / ashish patil
sudhir answer is write. to avoid over loading we swiched
of capacitor bank.we dont control power factor through
exciter in case of DG.
| Is This Answer Correct ? | 14 Yes | 7 No |
Post New Answer View All Answers
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
What was your role in the silicon evaluation/product ramp? What tools did you use?
what do you mean by plant earthing system.
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
What is the formula for calculating no-load current?
why the protection turbo generators is most complex?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What are dcs and plc?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What will happen if the d.c. Shunt motor opened accidentally running on no-load has its shunt field winding?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
