why three phase three wire system probably did'nt have neutral
- 2 Answers
- 6804 Views
- Marico, I also Faced
- E-Mail Answers
Answer Posted / sunil kumar das
Three phase three wire system is being used only for energy
tansmission purpose not for distrubition. that's why
neutral is not used.
| Is This Answer Correct ? | 20 Yes | 5 No |
Post New Answer View All Answers
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is mind in cable
Briefly describe your ideal job?
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
how can i determine the KVA/MVA rating of transformer precisely?? is there any standard test?????
What is the relationship between voltage,current & frequency?
What is inrush current?
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
Iwould like to know barc interview questions
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
where does 22kv line starts
I want to know Electrical Circuit?
