Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between AC voltage and DC voltage?
- 6 Answers
- 19210 Views
- I also Faced
- E-Mail Answers
Answer Posted / poonam
AC voltage is alternating voltage having frequency of 50Hz.
(60 Hz in US)
It has positive peak and negative peak value.
DC is direct voltage having 0 frequency and maintains
constant level.
| Is This Answer Correct ? | 63 Yes | 7 No |
Post New Answer View All Answers
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
What is mathematical model of a control system?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
can anyone give an idea about dia calculation in cold rolling mill
can u please mail me the syllabus for GET exam for damodar valley corporation?
Mention the disadvantages of low power factor? How can it be improved?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
what are the advantages and disadvantages of oil filled cables over XLPE cables
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
what is the difference between 2 way and 4 pole selector switch???
block diagram of 2 ups system connected in parallel mode?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
