why the power cut problems occur in tamil nadu?
may i know the exact reason.plz
Answer Posted / kumar
The electricity governmnt server and minister is not
satisfied.
Is This Answer Correct ? | 70 Yes | 25 No |
Post New Answer View All Answers
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
what is mean by dual digital protection in the relay field?
How much ph is maintained of water resistance starter for slipring induction motor ?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
why are installed water leakage detection system data centers & server rooms
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
State kirchoff voltage law?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
Define sensitivity?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?