Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO CHECK THERMOCOUPLE AND RTD & WHAT IS THE DIFFERENCE
BETWEEN THERMOCOUPLE AND RTD
- 14 Answers
- 99766 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinayak
rtd can be checked by measuring the resistance accross the
terminals. At room temp rtd has got a resistance around
110ohm when neasured across its terminal.
t/c can be checked by measuring mv at the terminals
connected. the corresponding mv is corelated with mv v/s
temperature chart to find the temp.
| Is This Answer Correct ? | 61 Yes | 11 No |
Post New Answer View All Answers
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Manipulation of dead wt. tester double piston type.
hi! i want to know about mpse exam.
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
what is a half wave, full wave, and bridge rectifer.
Explain operation of Haskel pump.
Operational amplifiers
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
why orfice is not used for main steam flow calculation
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
how u choose thermowell lenght n pnumatic C/v size?
what is the difference between -24 : +24 & 0:24 and where it use?
How to Calibrate Vibration Probe (Axial, Redial) in field
What is difference between Ionization heat and bimetallic heat
