Interested to Buy Any Domain ? << Click Here >> for more details...
why 3 phase motors are preferable over single phase motors ?
- 6 Answers
- 9549 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashwin . bhange
in the three phase motor at less power& current the motor
will work with good efficiency than the single phase motor
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
can anyone provide me a amf panel control wiring using ec-2 relay?
What is the cut-off rate?
in india per day how much power is generated including all power station
what is the difference between circular wdg & ractangular wdg?
What is the ratio of Booster transformer?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
What is resolution of a measurement?
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
how does a liquid starter reduce the starting currents?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
how can i reduce sparking without stepdowning the voltage
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
