Interested to Buy Any Domain ? << Click Here >> for more details...
why earth hole size is biggest in plug point?
- 13 Answers
- 29911 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / mahadeva
The resistance of the Conductor is depending upon the area
of cross section of conductor i.e(R=6L/A), so we are
connected earth wire to the big one terminal of the socket
point as well as 3 pin top. To flow the fault current
through the terminal to earth easily.
| Is This Answer Correct ? | 22 Yes | 2 No |
Post New Answer View All Answers
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What was the Dg set radiator and lube oil temperatures trip in ACB
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Give some differences between open loop and closed loop?
what is rocking arrangement in arc heating
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
What is the resonant peak?
What is mean by hot and cold loop testing? What is the difference between them?
What are dependent sources?
What is the formula to find out two phase active & reactive power
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
