Interested to Buy Any Domain ? << Click Here >> for more details...
Why Current Transformers cannot be connected in parallel
- 10 Answers
- 46136 Views
- I also Faced
- E-Mail Answers
Answer Posted / sekhar_anama
i think you know why we are connecting ammeter inseries in
the circuit.now,as we know the current will be flown in a
line thats why ammeter is connected in series.as we know
C.T is used to measure the currents in higher ratings.the
primary of the C.T has less number of turns with thick
conductor therefore the resistance of primary is very low
(R=rho*L/A),if CT is connected in parallel the CT acts as a
short circuit(low resistance of primary of CT).thats y it
will definetly burns out.if any answer is there plz mail me.
| Is This Answer Correct ? | 39 Yes | 18 No |
Post New Answer View All Answers
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
what are the possible reaons & remedies if resistance of NGR getting heat up
What is DTR erection?
What is d main advantage of using double circuit 3 phase transmission ?
How to connect the chemical earthing and complete process tell me plz
What is the meaning of HT Trivector Meter ?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
plz explain the auot-reclosing circuit in electrical engineeing
How many double suspension hardware fittings are required on a double circuit transmission tower?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
