Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / er. ankush miglani 9718151073
powe factor more than unity is possible but if it is so
the ckt becomes a sorce and starts supplying powr to the
mains
it happened coz the current starts leading voltage by an
angle mopre than 90 deg. and stsrts feeding the mains.
so powerv factor cant be more than 1
| Is This Answer Correct ? | 7 Yes | 32 No |
Post New Answer View All Answers
What is the function of under voltage release ?
hi,every one, i have to write the search paper on "performance policy optimization" of NGN (next generation networks). i need the material on this topic. can any body help me. please tell me any useful site where the good material is available and name of any reference book. it should be a great help for me.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
what are factors to be consider to design a HT & LT motor?
The synchronous machine excitation system explain
what is the difference between ac motor and dc generator
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
What is line resistance of cable & how it can be measured ?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
how to meas-our losses for L.T & H.T
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Pl. brief about break-down maintenance of machine tool.
