HOW many type of Circut Breaker in the world used in 400 kv
substation?
- 14 Answers
- 21067 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / suni
SF6 Vaccum circuit Breaker is used for 400KV substation
and above
| Is This Answer Correct ? | 80 Yes | 10 No |
Post New Answer View All Answers
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
1.how many types of relays? 2.difference between ATS& STS?
Difference between low impedance and high impedance Restricted Earth Fault
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
What is power relay?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
What is the Surge suppresor? Why using in a UDB's and How it works?
what is the ground fault relay,which purpose it will be use,clearly tell me plz
How to calculate the copper in HT motors if KW, RPM & Voltage is given
