How do you calculate of power factor, if it is lagging or
leading for unit(1).
Answer Posted / g.venkat reddy
angle diference between voltage and current,
Pf=truepower/apparent power,(KWH/KVAH),power/voltsxamps,
PF=R/Z
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
How to Preparation of online test
How can we choose the rating of submersible motors
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
what is difference between line differential and transformer differential?
Why we use circular(Stepped) cross section in transformer core?
How many gap between finger contact in a.c.b. and v.cb.?
how to calculate earth fault relay current and CBCT ratio
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
what is the usage of microcontroller in the panel board?
tell me about eletrical contractor
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?