Answer Posted / pavan
Our systems or some machinery needs certain amount of
voltage so that by using transformer we can stepup/stepdown
the voltage what our system needs.
| Is This Answer Correct ? | 18 Yes | 8 No |
Post New Answer View All Answers
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
what is doubling factor in making current of a breaker?
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
What are the characteristics of negative feedback?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
how to generator maintenance (A Check, B check,Etc)
in india per day how much power is generated including all power station
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
What is called grain-oriented laminations?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
why transmission is only 3 phase and not 2 or 4 or poly phases
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
Star Delta Diagram with full description