Interested to Buy Any Domain ? << Click Here >> for more details...
why do we use magnetic contactors ?circuit breakers are not
enough?
- 5 Answers
- 23432 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit biswas
magnetic contractor is more of a sequence swiitcing device
while later is aprotection device.
even the contractrs on papers can perform the operation of
a cb.But to my cognizance I had never seen any contracor at
HT level
every time a c b operates it required to chare the spring
manually (or motor but with manual interferance) which is
not in case of contractors
| Is This Answer Correct ? | 9 Yes | 10 No |
Post New Answer View All Answers
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
what is the method of earthing of a transformer using electrodes?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
what is the mechanical safety of DG ?
Why star delta starter is preferred with induction motor?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What is bode plot?
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
What do you mean by a current transformer?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
How could a garment factory benefit from renewable energy
how to calculate the breaking capacity of different breakers.
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
What is current & voltage ? Voltage perform at any load without current or not?
